14 TESTTOOLSFORLAB&FIELD | RF CAPTURE/PLAYBACK & GENERATE RF-LIVESIM TECHNICAL CHARACTERISTICS Standalone unit with PS/2 & VGA interfaces for screen-keyboard-mouse control 1x RF in, 1x RF out (isofrequency) 1x Ethernet port for remote control Full remote control via SCPI (Standard Commands for Programmable Instruments) protocol Signal level: output from -110 to -20 dBm without any interruption Frequency range from 50 to 900 MHz, resolution 1 Hz Variable bandwidth from 20 kHz to 20 MHz, resolution 1 kHz Channel Propagation Profile: 20 independent paths adjustable (amplitude, delay, phase, Doppler) Doppler profiles: -70 000 to +70 000 Hz (step 1 Hz), Amplitude distributions (Pure, Flat, Gaussian, Rayleigh, Rice) Frequency drift & hopping without loosing receiver synchronization Preset configurations: terrestrial broadcast profiles such as TU6, rural, indoor/ outdoor for fixed/portable devices as well as profiles for physical layers for WiMAX / LTE AWGN Generator: Signal+Noise, Burst noise, Impulsive noise, Noise only 1x TRIG, 1x 10MHz in & 1x 10MHz out 1U rack form (450x500x44) ORDERING CODE RF-LiveSim RF Live Channel Simulator - 50-900 MHz input/output - 1U rack • Chipset designers: complete modulator/demodulator testing • Receivers manufacturers: operating limit testing and robustness • R&D Laboratories: intensive non- regression testing, design/product verification APPLICATIONS • Real-time channel profile simulations • Up to 20 adjustable independent terrestrial paths • Several preset configurations available • Remotely accessible • Easy to use and configure • Test automation (SCPI compliant) KEY BENEFITS Covering a frequency range from 50 to 900 MHz, RF Live Simulator can emulate RF channels propagation modes for a signal bandwidth from 20 kHz to 20 MHz (gaussian noise, multipath, Doppler and frequency drift tools). RF-LiveSim is a cost effective solution for intense automatic non regression tests at the physical layer level. Real-timeRFChannelSimulator