• EdgeProbe for HDc - DTT 24/7 Monitoring Probes
  • Web GUI - Overwiew
  • Web GUI - Alarm Overview
  • Web GUI - Monitoring - Channel
  • Web GUI - Monitoring - T2-MI
  • Web GUI - Monitoring - Service Plan
  • Web GUI - Monitoring - Logs Events
  • Web GUI - Settings - Channel Management
  • Web GUI - Settings - Alarm Profiles - T2-MI
  • Web GUI - Settings - Alarm Profiles - Multiplex
  • Web GUI - Device - General
  • Web GUI - About

DVB-T/T2 Advanced Monitoring Probe for HDc
HDmE DVB-T/T2

Rated 5.00 out of 5 based on 1 customer rating
(1 customer review)

The ideal tool for accurate & cost-effective monitoring of the quality actually delivered to all points of DVB-T and DVB-T2 networks.

Category:

Applications

  • 24/7 Monitoring and Maintenance of both Head-End and TX sites (SFN/MFN, RF/Baseband)
  • Generation of Service Availability reports for Service Level Agreements
  • Rebroadcasting receiver: RF to ASI or IP, with transcoding capacities
  • Live transmission recorder

Benefits

  • Standalone, easy to use and configure, fast deployment, SNMP compatible
  • Increase customer satisfaction by detecting & preventing DTV network degradations before your customers do
  • Reduce TX sites maintenance cost by anticipating and identifying issues
  • Plan and improve the network configuration by identifying global trends
  • Remotely accessible, compatible with low bandwidth control networks (GPRS/3G)
  • Low power consumption 20W
  • Compatible for High Density Chassis: 6 monitoring probes in 1RU

Combined with a Network Monitoring System or not, the EdgeProbe Advanced provides a powerful broadcast network alert & diagnosis tool allowing DTV network operators to monitor global trends and anticipate potential failures.

EdgeProbe Advanced is able to monitor DVB-T and DVB-T2 signals at transmitter outputs, through its RF inputs (up to 6 in 1RU), as well as at modulator input and at Head-End/distribution links, through its ASI and IP inputs.

Monitor DVB-T & DVB-T2 signals at TX output through the RF inputs (up to 6 in 1RU)

Signal Level, MER, SNR, BER

Modulation parameters, L1 signaling in DVB-T2, TPS in DVB-T

Channel Impulse Response

DVB-T, DVB-T2 (1.1.1, 1.2.1, 1.3.1) & T2 Lite support

Monitor RF signal SFN synchronisation

RF Frame Delay & Drift

Carrier Frequency Offset & Drift

Quick identification of which TX site is causing SFN issues!

TS over ASI/IP Input/Output

Monitor TS, T2-MI, OneBeam & BTS baseband distribution links at Head-End output and TX site input through the ASI/IP inputs (up to 6 in 1RU)

RTP FEC, VLAN support the IP input

IP input jitter monitoring

Forward the analyzed TS over ASI or IP output

Complete MPEG-2 TS Monitoring

ETSI TR 101 290 Priority 1, 2, 3

QoS indicators (optional): Service Availability Error & Service Degradation Error

Verify Regionalization: Service Plan view, PID/Service presence, Scrambling

Service & components bitrates

T2-MI, BTS & OneBeam Monitor

ETSI TR 101 290 T2-MI packet alarms

T2 L1 pre/post signaling

T2-MI PLP TS analysis and extraction support

BTS: IIP, TMCC packets monitoring

OneBeam: T2-MI marker and In-Band PID monitoring

Transcoding solution for confidence monitoring

Coupled with a TRANSBOX device, EdgeProbe can provide service transcoding and forward to third-party analysis systems :

Controlled by the EdgeProbe, the TRANSBOX performs

-Service extraction from the input MPEG-2 TS (SPTS or MPTS)

-Real-time audio/video transcoding: 1 to 10 Mbps output bitrate

-Transcoded MPEG-2 SPTS forward over IP Data

32 GB of internal storage (up to 4 in 1RU)

Alarm logs up to 6 months

RF parameter trends up to 6 months

TS recording (manual trigger)

Internal GNSS receiver (Hardware option)

Generates an internal 1PPS reference signal for SFN synchronization measurements (SFN Drift, Frequency Offset)

GPS & GLONASS support

Dual Power Supply (Hardware option):

– additional Power Supply can be installed on the equipment in order to ensure the power redundancy

Compatible with all Network Monitoring Systems

Powerful network alert & diagnosis tool: monitor global trends and anticipate potential failures

Compatible SNMP v2c and v2c INFORM for alarming and device configuration

Web GUI access: support of low bandwidth Internet connection (3G, GPRS)

HDc support

Density: up to 6 monitoring probes in 1RU

Modular: multi-standard monitoring probes in the same RU; ENENSYS Technologies HDmx equipment support

Hot Plug & Reliable

INTERFACES

  • RF
  • *

  • Connector In
  • Up to 6x RF inputs (F-type female – 75 Ω)

  • Standards
  • DVB-T, DVB-T2 (including 1.3.1), DVB-T2 Lite

  • Frequency range
  • 40 to 1000 MHz

  • Sensitivity
  • -80 to -5 dBm

  • TS
  • Up to 6x ASI in/out (BNC-type female – 75 Ω)

  • *
  • Up to 6x Gigabit Ethernet for Data in/out (VLAN support)

  • GNSS & Time Reference
  • 1x GNSS antenna input (GPS/GLONASS) HW option

  • *
  • 1x 1PPS input (BNC-type female – 50 Ω)

  • *
  • 1x 10MHz input (BNC-type female – 50 Ω)

MONITORING FEATURES

  • RF Monitor
  • *

  • Demodulation status
  • Lock / Unlock

  • Signal level
  • -90 to -5 dBm ±1 dBm, typically ±0.5 dBm, resolution 0.2 dBm

  • MER
  • 0 to 40 dB (0 to 36 dB: ±1 dB, 36 to 40 dB: ±2 dB)

  • BER (DVB-T)
  • Pre/Post-Viterbi, Post-RS

  • BER (DVB-T2)
  • Pre/Post-LDPC, Post-BCH

  • Modulation parameters
  • L1 signaling in DVB-T2, TPS in DVB-T

  • Channel Impulse Response (CIR)
  • *

  • Synchronization Monitor
  • *

  • SFN Drift
  • Measured at RF level. Allows rapid identification of which TX site is causing SFN issues

  • Network Delay
  • Transmission time for the SFN signal

  • Frequency Offset & Drift
  • Measured at RF level

  • T2-MI Monitor
  • ETSI TR 101 290 T2-MI packet, L1 pre/post signaling

  • *
  • PLP extraction and TS PLP analysis

  • OneBeam/Single Illumination
  • Specific PID from the DTH stream used to recover the T2-MI distribution on TX site

  • TS Monitor Base
  • MPEG-2 TS Monitor, ETSI TR 101 290 Priority 1 and 2

  • TS Monitor Advanced
  • ETSI TR 101 290 Priority 3, QoS (SAE/SDE)

  • Service Plan Monitor
  • Verify regional services, Service & PID bitrates, Scrambling, Service & PID presence

  • Scanning
  • Monitor sequentially multiple channel frequencies or PLPs

  • Extended Memory
  • Up to 6x 32 GB of internal storage: event logs up to 6 months, trends up to 6 months, TS recording

  • TRANSBOX
  • Coupled with a TRANSBOX device, EdgeProbe can provide service transcoding and forward to third-party analysis systems: service extraction from the input TS (SPTS or MPTS), real-time audio/video transcoding: 1 to 10 Mbps output bitrate, transcoded SPTS forward over IP Data

PHYSICAL

  • Height: 45 mm / 1.7 in, Width: 440 mm / 17.3 in, Depth: 300 mm / 11.8 in
  • Format: 1 RU, width 19”, Power supply: 100-240 VAC +/-10%
  • Power consumption: 20W, Redundant Power Supply (HW option)

ENVIRONMENT

  • Operating temperature
  • -20 to 55°C / -4 to 131 °F

  • Storage temperature
  • -20 to 70°C / -4 to 158°F

  • Humidity
  • 0 to 95%, non condensing

EdgeProbe Advanced DVB-T/T2 for HDc includes by default:

  • Hardware: 1 monitoring Unit 1x (RF in, ASI in/out, IP Data in/out) & 1x IP Control in 1 RU
  • Software:
    • DVB-T/T2 RF monitor: RF parameters, SFN (RF Frame, Carrier frequency), Channel Impulse Response
    • TS forward over ASI or IP outputs
    • VLAN support for IP Data lin

Software Options

  • TS Base Monitor: ETR290 Priority 1, 2
  • TS Advanced Monitor: ETR290 Priority 3
  • Qos Monitor: SAE (Service Availability Error), SDE (Service Degradation Error)
  • T2-MI Monitor: ETR290 T2-MI parameters
  • BTS Monitor: IIP & TMCC packet monitoring
  • Service Plan: Multiplex Service/PID monitoring
  • Extended Memory: 32 GB storage (trends, logs, TS record)
  • OneBeam/Single Illumination: T2-MI markers monitoring
  • Scanning: Multiple RF/ASI/IP channels sequential monitoring

Hardware Options

  • Internal GNSS receiver
  • Dual Power Supply
  • TRANSBOX: Stream 1 or 2 compressed service(s)
  • Tropicalization: Preserve the HW from corrosion – chassis & electronic component treatment for tropical and salty environment

 

Default Warranty

  • Standard: 1 YEAR Hardware Warranty and Basic Helpdesk (HW RMA)

Optional Support Services

  • Advance HW + SW 1/3/5 YEAR including:
    • Advance Replacement: hardware warranty with replacement before reception of faulty unit
    • Software Upgrade: access to all software updates & upgrades
    • Priority HelpDesk: priority access to the support helpdesk for any question on product usage, problem request, and change/improvement requests
  • Premium HW 1/3/5 YEAR including:
    • Premium Advance Replacement : hardware warranty with 1 business day replacement before reception of faulty unit (from a dedicated customer spare stock)
  • Premium SW 1/3/5 YEAR including:
    • Premium Software Support: SLA contract manager + guaranteed response time + 2 days per year local proactive visit (training including presentation of new available features, 1 TX site & or HE visit & configuration improvement, discussion on needs for new functionalities)
    • Software Upgrade: access to all software updates & upgrades
    • Priority HelpDesk: priority access to the support helpdesk for any question on product usage, problem request, and change/improvement requests

More details on the Waranties page.

Documents

Related products

comments

Rated 5.00 out of 5
(1 Customer reviews)

    Show reviews in all languages (1)

  1. Rated 5 out of 5

    David Arnaldi – Airtel

    Awesome product !

Add a review

Your email address will not be published. Required fields are marked *